71
GUARDS
General Information
Guiding Guard Wear
End and center guiding guards have no
definite measurement technique, service
limits or wear charts.
They should, however, be a part of every
undercarriage inspection and their condi-
tion should be described in subjective but
comparative terms.
Guiding guard wear on pin ends is a good
indicator of guiding guard condition but
should not be assumed to be the only indi-
cator since wear strips might have been
replaced since the track was first installed.
Guiding guard replaceable wear strips
should be replaced before any wear or
damage is done to the guard itself. The most
convenient time to check and maintain
guard wear strips is at pin and bushing
maintenance and track replacement time.
Need for Roller Guards
Full Roller Guard
Partial Roller Guard
Although roller guards (full or partial
type) do provide some additional guiding
effect, their use should be based on the
need to keep rocks and/or other foreign
debris from entering the roller areas.
Roller guards should not be used therefore
in any condition where there is no danger
of rocks and debris entering the spaces
between the rollers and causing roller, link,
bushing or sprocket structural damage.
Roller guards should be considered when
working in the following types of materi-
als only, and when structural damage to
rollers, links, bushings and sprocket has
been or may be a problem.
Conditions for Use
of Roller Guards
1. Rocks or gravel of 1" (25 mm) or larger
up to 6" (150 mm).
2. Tree limbs, branches or other non-
extrudable wood products or waste
materials.
3. Sanitary landfill and demolition materials
only if large metal, wood or other high
strength objects of 1"-6" (25-150 mm) in
size are frequently encountered.
Remember, roller guards should only be
used to keep foreign objects out, not for
their increased track guiding contribution.
The Disadvantages of using Roller
Guards in the wrong conditions or for
the wrong reasons are these:
1. Difficulty in measuring, inspecting
and maintaining rollers.
2. Help keep packing material in —
doesn’t help keep it out.
3. May unnecessarily increase wear on
link rail sides, pin bosses and on pin
ends.