14
ALIGNMENT
General Information
Alignment for all Track Type Machines
excluding *D9R (SN 7TL1212-up and
8BL1422-up) *D10R (SN 3KR1331-up) and
*D11R (SN 9TR202-up and 9XR154-up).
Proper roller frame, idler and sprocket
alignment is important to avoid accelerated,
unbalanced wear on moving undercarriage
components (roller tread and flanges, link
rails and rail sides and sprocket segment or
rim sides).
As a general rule any wear pattern differ-
ences between left and right, inner and
outer, or front and rear may be due to
improper alignment of one or more parts
of the roller frame, idlers or sprocket.
Complete discussion on checking and
measuring roller frame alignment plus
straightening procedures are discussed in
Special Instruction SEHS8146-01 avail-
able from Service Publications.
Here is a description of the more common
types of alignment problems, their cause,
effect, and the steps required to correct the
cause:
*Note: These machines have unique Track Roller
Frame alignment to increase link and roller life.
This is further detailed in Service Magazine SEPD0469.
Roller Frame
(including diagonal brace)
Toe-In and/or Toe-Out
When viewed from the top, either or both
of the roller frames is not parallel to the
center line of the tractor.
CAUSE: temporarily (during load only)
or permanently bent diagonal brace or
roller frame
EFFECT: unbalanced wear when compar-
ing inboard versus outboard roller and
idler flanges and rail sides — rollers wor-
sen from rear to front
REMEDY: straighten diagonal braces and
repair mounting bearings
Tilt
When viewed from front or rear the roller
frame tilts toward or away from tractor.
CAUSE: permanently bent diagonal brace,
broken mountings or bearings
EFFECT: unbalanced wear when compar-
ing inboard versus outboard roller, idler,
link treads and flanges — unbalance from
front to rear on rollers
REMEDY: straighten diagonal brace and/
or repair mountings