Application Conditions
The word “applications,” often misused to
describe underfoot condition, should be
thought of as describing what the machine
is doing. Below is a brief description of
the possible wear and structural effect of
each of several common “applications,”
but without regard to what underfoot con-
ditions the machine is in.
Dozing and Push Loading
Shifts machine weight toward the front
causing faster wear rate on front rollers
and idlers than on rear rollers.
Ripping and Drawbar
Shifts the weight balance towards the rear
of the machine with the effect of relatively
increasing wear rate on rear rollers than
front, and the sprocket and bushing in
extreme cases.
Loading
Shifts weight from front to rear of machine
as it changes from digging to carrying
respectively. The greatest effect is increased
wear on front and rear rollers as compared
with center rollers.
Excavating with Hydraulic
Excavators
Shifts weight balance from left to right of
machine with the possible effect of wearing
outer link treads, roller treads and flanges at
a greater rate than inner flanges and treads.
Partially Controllable
Variables
Some of the variables affecting undercar-
riage life can only be partially controlled.
To some extent they may be influenced by
uncontrollable variables but they can be
offset by the operator. We call these oper-
ating conditions.
The word “operating,” often misused to
describe the underfoot or application con-
ditions, should be thought of in describing
what the machine operator is doing. These
operator induced variables may or may not
be a function of the underfoot conditions,
the type of machine or even the applica-
tion and terrain.
Speed
Wear rate is a direct function of speed
because wear is a function of distance
traveled and not just the time worked.
As speed increases, wear rates increase pro-
portionally on all components. Wear rates
and impact (structural) effects also increase
proportionately with speed due to the
increased material loads caused by the rate
at which the parts contact each other. Link-
roller, link-carrier roller, link-idler and bush-
ing-sprocket wear rates increase as a result
of the increased impact between these
parts. Shoe and grouser wear rates increase
due to the increased impact with the ground.
High speed reverse has a particular effect on
the bushing-sprocket contact wear rates due
to the design of the track. Non-productive
speed should be discouraged. Non-productive
forward-reverse direction changes should
be avoided.
Turning
Wear rates increase with increased turning.
Turning increases interference loads
between links and rollers and links and
idlers, particularly on rail sides and roller
and idler flanges. Turning in reverse can
accelerate bushing sprocket wear as
compared to turning in forward. The effects
of always turning in one direction can be
balanced by changing tracks from one side
of the machine to the other half way
through their life.
Slipping Tracks
Wear rates on all components increase
when tracks are slipped. Track shoe
grousers particularly are affected when
tracks are slipped due to the increased
sliding between the grouser and the
ground. The increased loads that slipping
tracks cause is accelerated when the
ground is resistive to shear.
25
General Information
PARTIALLY CONTROLLABLE VARIABLES