Reverse and/or Forward Drive Side
(30° to 60° from vertical)
CAUSES: Same as VERTICAL POSI-
TION except degree of packing is moder-
ately severe.
ACCELERATORS: Same as VERTICAL
POSITION but particularly tight track.
EFFECT: VERTICAL POSITION should
overtake FDS or RDS as most worn
position in later hours if track is properly
adjusted and new segments are not
installed prematurely.
REMEDIES: Eliminate controllable accel-
erator variables, particularly tight track.
Bushing should be turned at or before
service limit.
Reverse and/or Forward Drive Side
Pocket Wear
(60° to 90° from vertical)
CAUSES: (1) Same as VERTICAL and
FDS/RDS except packing is very severe.
(2) Track is too loose causing “backjam-
ming” as reverse motion at bottom of
sprocket on RDS only.
ACCELERATORS: (1) Same as “Vertical
Position” and FDS/RDS (2) Same as
“Vertical Position” and FDS/RDS except
track tension, which needs to be increased.
Uphill reverse loading of machine with
too loose track is biggest accelerator.
EFFECT: (1) Vertical position should
overtake either pocket as most worn
position in later hours if track is properly
adjusted and new segments are not
installed prematurely. (2) Track may jump
on sprocket if sprocket tooth tip height is
worn excessively and track remained too
loose.
REMEDIES: (1) Eliminate or reduce con-
trollable accelerator variables. Turn bushing
before this position reaches 120 percent
regardless of the vertical position percent
worn. Do not install new segments prema-
turely. (See discussion on use of sprocket
reuse gauge.) (2) Adjust track as recom-
mended in the individual product sections.
Install new segments only if tip height is
reduced significantly and there is no mod-
erate to severe packing. Turn bushings
before this position reaches 120 percent
regardless of vertical position percent worn.
Off Center Wear
CAUSES: Misalignment of track and
sprocket.
ACCELERATORS: (1) Various roller
frame and sprocket alignment problems.
(2) Worn rear guiding and/or final drive-
guiding guards. (3) Side-hill operation.
EFFECT: Should not increase wear rate of
bushing to wear limits, but may reduce
bushing retention if accompanied by impact.
REMEDIES: (1) Correct alignment. (2)
Replace guiding and final drive-guiding
guards.
40
SEALED & LUBRICATED TRACK PINS & BUSHINGS
General Information