Shoe Structural Problems
All shoe structural problems described
here should be considered for their own
cause plus for the transferred effect into
the rest of the undercarriage components.
Shoe Bending, Cracking
and Breaking
CAUSES: Bending load on shoe exceeds
shoe beam strength due to (1) loss of
grouser and plate wear material (2) shoe
too wide for underfoot conditions.
ACCELERATORS: Same as “Shoe
Grouser Wear,” particularly shoe width.
EFFECT: Loss of unused shoe wear life.
Loss of re-grouserability.
REMEDIES: Choose heavier extreme
service shoe and/or narrower shoe which
will give adequate flotation.
Bolt Hole Wallowing Out
(With loose hardware)
CAUSES: Loss of clamping between shoe
and link or loose bolt pounds hole larger.
ACCELERATORS: (1) Same as “Shoe
Bending Cracking and Breaking” particularly
too wide shoes, plus having too much turning
resistance resulting from too high grouser. (2)
Inadequately tightened hardware.
EFFECTS: Loss of unused shoe wear life;
loss of shoe regrouserability; damage to
link bolt holes and resulting loss of wear
life and rebuildability.
REMEDIES: (1) Choose narrowest shoe
which will give adequate flotation. Clip
ends of grouser to reduce turning resistance
of wide shoes. (2) Choose multigrouser
shoes to reduce turning resistance. (3)
Choose extreme service shoe if single
grouser shoe is bent.
Tighten (and retighten) hardware if neces-
sary according to proper torque procedure
and specifications.
Proper Shoe Selection
Shoe selection should be based on the
user’s habits, general preference, expected
specific needs or the machine salesmans
advice. Often, this preference and advice
is premised strictly on machine productiv-
ity without consideration given to the
effect on the total undercarriage wear
and/or structural life in hours or cost per
hour terms.
It is the responsibility of the CTS analysts
to be the expert in all facets of shoe selec-
tion, both in regard to machine productiv-
ity and undercarriage wear and structural
life performance.
Any choice is a compromise. Make the user
aware of the advantages (productivity) and
disadvantages (reduced undercarriage com-
ponent life). The best example is the case
of low ground pressure (machines with
very wide shoes) which vastly increases
productivity by working in places no other
machine could, but with an expected under-
carriage wear and structural life of as little
as 1/10 of the same sized machine work-
ing on firm soil with standard width shoes.
Use the following chart to weigh the factors.