Dry Joints — Link assemblies should be
checked weekly for dry joints. This should
be done by lightly touching the pin end or
bushing after a machine has been working.
A dry pin or bushing will be relatively
warmer from metal-to-metal friction.
CAUTION — the pin and bushing of a
dry joint may be hot enough to burn
fingers.
Warm, squeaking and kinking joints are
only indicators of potential dry joints. The
only positive means of determining
whether a dry track joint has developed is
when pitch extension occurs. The decision
to remove the track from the machine
should be based on pitch extension only.
Measure the next pin away from the dry
joint in both directions to be sure you have
recorded the pitch extension correctly.
The single joint pitch extension should
not exceed the wear limits shown in the
following chart.
Dry Joint Wear Limit
New Track Single Joint
Model Pitch Wear Limit
D4H 6.75" (171 mm) 7.00" (177 mm)
D5M, D5N
561M, 561N
D5H 7.50" (190 mm) 7.75" (196 mm)
D6M, D6N
517
D6H, D6R 8.00" (203 mm) 8.25" (209 mm)
527
D7H, D7R 8.50" (216 mm) 8.75" (222 mm)
D8L, D8N, D8R
572R
578
583R
D9L, 589 9.00" (229 mm) 9.25" (235 mm)
D9N, D9R 9.45" (240 mm) 9.70" (246 mm)
D10 10.25" (260 mm) 10.50" (266 mm)
D10N, D10R
D11N, D11R 12.50" (318 mm) 12.75" (324 mm)
101
COMPONENTS
Elevated Sprocket Machines
Shoe & Master Link Bolt Torque Specifications
Additional Turn
Bolt Master Link
Model Size Torque* Regular Shoe Master Shoe
D4H 5/8" 130 ± 30 ft. lb. +1/3 turn +1/2 turn
D5H, D5M, D5N 175 ± 40 Nm
561M, 561N
D5H 3/4" 300 ± 50 ft. lb. +1/3 turn +1/3 turn
D6M, D6N 400 ± 70 Nm
D6H, D6R
D7H
572R
517
527
D7H, D7R 7/8" 250 ± 50 ft. lb. +1/3 turn +1/3 turn
340 ± 70 Nm
D8L, D8N, D8R 7/8" 480 ± 50 ft. lb. +1/3 turn +1/3 turn
578 650 ± 70 Nm
583R
D9L, D9N, D9R 1" 650 ± 50 ft. lb. +1/3 turn +1/3 turn
589 870 ± 70 Nm
D10 1-1/8" 650 ± 50 ft. lb. +1/3 turn +1/2 turn
D10N, D10R 870 ± 70 Nm
D11N, D11R 1-3/8" 1100 ± 100 ft. lb. +1/3 turn +1/2 turn
1500 ± 150 Nm
*Use the assembling and torque turn tightening procedures on pages 33 and 55.