Bushing Allowable Wear — Bushing
allowable wear is based on the remaining
strength to resist cracks. For low sprocket
machines, the choice between two allow-
able wears is based on high or low impact
conditions because the sprocket is close to
the ground and subject to impact.
Pin and Bushing — Sealed
Track — Internal
Measurement — Sealed track internal
wear is measured by determining the pitch
extended length over four adjacent sec-
tions with a tape measure calibrated in
0.02" (0.5 mm) increments. The track
must be tight before measuring. Measure
from the side of one pin to the same side of
the fifth pin away (which includes 4 sec-
tions). See details on measurement pro-
cedure on page 48.
Shoes
See pages 51 through 55 for detailed shoe
information.
Measurement — Use the depth gauge or
the Ultrasonic Wear Indicator to measure
shoes.
252
COMPONENTS
Low Sprocket Machines
Shoe & Master Link Bolt Torques
Additional Turn
Bolt Master Link
Model Size Torque* Regular Shoe Master Shoe
D3 1/2" 130 ± 25 ft. lb. — —
D4 175 ± 40 Nm
931
933
935
D3 9/16'' 65 ± 15 ft. lb. +1/3 turn +1/2 turn
D4 90 ± 20 Nm
931
933
935
D4 5/8'' 130 ± 30 ft. lb. +1/3 turn +1/2 turn
D5 175 ± 40 Nm
D6
941
951
561
D6 3/4'' 220 ± 40 ft. lb. +1/3 turn +1/2 turn
D7 300 ± 50 Nm
955
977
571
572
D8 7/8'' 250 ± 50 ft. lb. +1/3 turn +1/2 turn
983 340 ± 70 Nm
D9 1'' 400 ± 50 ft. lb. +1/3 turn +1/2 turn
594 540 ± 70 Nm
* Use the assembling and torque turn tightening procedures on pages 33 and 55.