Forward and Reverse Drive Sides
Critical Compared to Vertical
(30° to 60° from vertical)
CAUSES: Sliding motion of bushing against
sprocket under abnormal interference loads
(characteristic of high internal wear in any
application or condition).
ACCELERATORS: Same as “FDS and
RDS Critical” described above especially
track which has been over tightened to
compensate for snakiness.
EFFECT: Can cause bushing cracking
before or after turn if service point exceeded.
REMEDIES: Eliminate controllable accel-
erator variables, especially over-tight track
and turn based on internal wear to service
point. Convert to Sealed and Lubricated
Track.
Off-Center Wear Pattern and Roller
Flange Wear Pattern.
See “How to Interpret Sealed and Lubri-
cated Track Bushing Wear Patterns.”
Other Wear Patterns —
Disassembled Track
Bushing End Wear
CAUSES: Sliding contact between inside
seal or abrasive and link counterbore
bottom (usually directly related and a
result of the degree of internal wear and
snakiness and not a cause of snakiness).
ACCELERATORS: All machine horse-
power, weight and speed related loads; all
loads related to side thrust caused by
terrain and maneuvering; abrasiveness.
The only controllable accelerator variables
are shoe width and condition of guiding
components.
EFFECTS: Reduces re-sealability of joint
at turn time. Reduces internal wear life
and link rebuildability after turn.
REMEDIES: Turn pins and bushings at
service limit. Keep guiding components in
good condition.
46
SEALED TRACK PINS & BUSHINGS
General Information