Wear Patterns — The undercarriage
design of elevated sprocket machines and
the absence of “snakiness” in Sealed and
Lubricated Track allow it to “track” very
straight. This straight tracking causes the
roller to wear with a slight ridge running
down the center of the tread. This ridge
results from less wear occurring on the
center of the roller tread as it passes over
the links in their overlap area. The ridge
on the roller may in turn wear a groove
down the center of the link rail. This wear
pattern is normal for these machines. It
may occur less often on machines with
non-suspended undercarriage. D9R,
D10R, and D11R machines with improved
alignment undercarriage also minimize or
eliminate this wear pattern.
As elevated sprocket undercarriage wears,
a larger scallop develops over the link
strut than on oval undercarriage machines.
This is because the track link goes around
two idlers instead of one. This wear is not
considered critical. Evaluate link wear
based on wear directly over the pin area.
Split Master Links — Use the assembly
procedures on page 33 for split master
links. Refer to “Shoes” on the following
page for bolt torque specifications.
Pins and Bushings
Elevated Sprocket Machines use Sealed
and Lubricated Track. See pages 36
through 43 for details. The following
points are specifically for elevated sprocket
machines:
Measurement — Use the caliper or the
Ultrasonic Wear Indicator to measure all
three bushing contact sides: forward,
reverse, and vertical. Use the most worn
position to make projections. This practice
is necessary because wear can occur in all
three positions, depending on the degree
of packing. The depth gauge should not be
used before a bushing turn because it only
measures vertical bushing wear. After a
bushing turn, the depth gauge can be used
to approximate wear based on the vertical
dimension.
Bushing Allowable Wear — Bushing
allowable wear is based on the remaining
strength to resist cracks. For low sprocket
machines, the choice between two allow-
able wears is based on high or low impact
conditions because the sprocket is close to
the ground and subject to impact.
The choice between the two allowable
wears for elevated sprocket machines is
different because the sprocket is not
subject to impact. For machines in under-
foot conditions which have only fine
granular materials, use the chart showing
the greater allowable wear. For all other
conditions use the chart with lesser allow-
able wear.
100
COMPONENTS
Elevated Sprocket Machines