
118 KENR8601
Troubleshooting Section
D. Measure the resistance from the wire that was
disconnected from pin 36 of the GSC+P to
“BATT+” of the GSC+P.
Expected Result:
The resistance is greater than 5000 ohms.
Results:
•
OK – The resistance is greater than 5000 ohms.
The circuit is co rrect. 3
•
NOT OK – The resistance is less than 5000 ohms.
The circuit is not correct. The spare output is
shorted to “BATT+”.
Repair: Repair the wiring of the spare output relay.
STOP.
Te st Step 3. RECONNECT TO
CUSTOMERS’ DEVICE
A. Reconnect the wire to the customers’ device.
B. Reconnect the wire that was disconnected from
pin36totheGSC+P.
C. Turn the Engine Control Switch (ECS) to STOP
and check if the diagnostic code is still active.
Expected Result:
The diagnostic code is not active.
Results:
•
OK – The diagnostic code is not active. It is likely
that the problem was in the wiring harness or the
problem is intermittent.
Repair: Check the wiring between the GSC+P
and the customer device for problems. Repair the
wiring or replace the wiring if a problem is found.
Watch for a recurrence of the diagnostic c ode.
STOP.
•
NOT OK – The diagnostic code is still active.
There may be a problem with the customer device.
Repair: Ensure that the custome r device does
not draw more than 100 mA. Also, the customer
device may have failed. Refer to the customers’
documentation and the dealers’ documentation for
the device.
STOP.