
Product: SKID STEER LOADER
Model: 226B SKID STEER LOADER MJH
Configuration: 216B 226B 232B 242B Skid Steer Loader MJH00001-10574
(MACHINE) POWERED BY 3024C Engine
Operation and Maintenance Manual
216B, 226B, 232B, 236B, 242B, 246B, 248B, 252B, 262B and 268B Skid Steer Loaders
Media Number -SEBU7731-08 Publication Date -01/07/2007 Date Updated -16/07/2007
i01329099
Burn Prevention
SMCS - 7000
Do not touch any part of an operating engine. Allow the engine to cool before any maintenance is
performed on the engine. Relieve all pressure in the air system, in the oil system, in the lubrication system,
in the fuel system, or in the cooling system before any lines, fittings or related items are disconnected.
Coolant
When the engine is at operating temperature, the engine coolant is hot. The coolant is also under pressure.
The radiator and all lines to the heaters or to the engine contain hot coolant.
Any contact with hot coolant or with steam can cause severe burns. Allow cooling system components to
cool before the cooling system is drained.
Check the coolant level only after the engine has been stopped.
Ensure that the filler cap is cool before removing the filler cap. The filler cap must be cool enough to touch
with a bare hand. Remove the filler cap slowly in order to relieve pressure.
Cooling system conditioner contains alkali. Alkali can cause personal injury. Do not allow alkali to contact
the skin, the eyes, or the mouth.
Oils
Hot oil and hot components can cause personal injury. Do not allow hot oil to contact the skin. Also, do not
allow hot components to contact the skin.
Remove the hydraulic tank filler cap only after the engine has been stopped. The filler cap must be cool
enough to touch with a bare hand. Follow the standard procedure in this manual in order to remove the
hydraulic tank filler cap.
Batteries
Electrolyte is an acid. Electrolyte can cause personal injury. Do not allow electrolyte to contact the skin or
the eyes. Always wear protective glasses for servicing batteries. Wash hands after touching the batteries
and connectors. Use of gloves is recommended.