
1. Fasten the seat belt.
2. Pull the armrest downward.
3. Move the governor control lever to the low idle position.
4. Before the engine is started, check for the presence of bystanders or maintenance personnel. Ensure
that all personnel are clear of the machine. Briefly sound the forward horn before you start the
engine.
5. Turn the engine start switch key to the ON position.
NOTICE
Do not operate the glow plugs for more than 30 seconds at
one time. Damage to the glow plugs could occur.
6. Press the glow plug switch and hold the switch for the time specified in the following tables:
Table 1
216B, 226B, 232B, 242B, 247B, 257B
Ambient Temperature Preheat time for the Glow Plugs
greater than
0 °C (32 °F)
6 seconds
0 °C (32 °F) to
-18 °C (0 °F)
10 seconds
-19 °C (-2 °F) or colder
30 seconds
Table 2
236B, 246B, 248B, 252B, 262B, 268B, 267B, 277B, 287B
Ambient Temperature Preheat Time for the Glow Plugs
-9 °C (15 °F) or colder
10 seconds
Note: For ambient temperatures of -27 °C (-16 °F) or colder it is recommended to use a jacket water
heater in addition to glow plugs.
NOTICE
Do not crank the engine for more than 30 seconds. Allow
the electric starting motor to cool for two minutes before
cranking the engine again.