
Illustration 2 g01017632
4. Inspect the condition of the belt (1) and the adjustment of the belt. The belt should deflect 10 mm
(0.39 inch) under a straight pull of 44 N (10 lb). This measurement should be taken between the
alternator pulley and the crankshaft pulley.
Note: A 144-0235 Borroughs Belt Tension Gauge may be used to measure belt tension. This
measurement should be taken between the alternator pulley and the crankshaft pulley. Refer to the
following table for belt tension.
Table 1
Belt Tension
Initial
Belt Tension
Used
534 ± 22 N (120 ± 5 lb) 400 ± 44 N (90 ± 10 lb)
5. Loosen the mounting bolt (2). Loosen the adjusting locknut (3) .
6. Move the alternator until the correct tension is reached.
7. Tighten the adjusting locknut. Tighten the mounting bolt.
8. Recheck the belt deflection. If the amount of deflection is incorrect, repeat step 4 to step 7.
9. Install the guard for the V-belt.
10. Close the engine access door.
Copyright 1993 - 2012 Caterpillar Inc.
All Rights Reserved.
Private Network For SIS Licensees.
Sat Jan 28 2012 04:24:32 GMT-0800 ( ( ))