
Product: SKID STEER LOADER
Model: 226B SKID STEER LOADER MJH
Configuration: 216B 226B 232B 242B Skid Steer Loader MJH00001-10574
(MACHINE) POWERED BY 3024C Engine
Operation and Maintenance Manual
216B, 226B, 232B, 236B, 242B, 246B, 248B, 252B, 262B and 268B Skid Steer Loaders
Media Number -SEBU7731-08 Publication Date -01/07/2007 Date Updated -16/07/2007
i02881645
Drive Chain Tension - Check/Adjust
SMCS - 3261-025; 3261-535
Note: Steel tracks that go over the tires should only be used with pneumatic tires. When you
use steel tracks that go over tires or any drive train device except tires, the interval for checking the drive
chains should be reduced to every 100 Service Hours. The use of rubber tracks that go over the tires is not
recommended.
Note: There are four drive chains on the skid steer loader that must be checked and adjusted.
1. Park the machine on level ground and stable ground.
2. Chock the rear tires.
3. Use an appropriate floor jack to lift the front of the machine so that the front tires are off of the
ground. Block up the front of the machine with two 1U-9758 Jack Stands .