
Product: SKID STEER LOADER
Model: 226B SKID STEER LOADER MJH
Configuration: 216B 226B 232B 242B Skid Steer Loader MJH00001-10574
(MACHINE) POWERED BY 3024C Engine
Operation and Maintenance Manual
216B, 226B, 232B, 236B, 242B, 246B, 248B, 252B, 262B and 268B Skid Steer Loaders
Media Number -SEBU7731-08 Publication Date -01/07/2007 Date Updated -16/07/2007
i01961213
Cooling System Coolant (ELC) - Change
SMCS - 1395-044-NL
Pressurized system: Hot coolant can cause serious burn. To
open cap, stop engine, wait until radiator is cool. Then
loosen cap slowly to relieve the pressure.
NOTICE
Mixing ELC with other products will reduce the
effectiveness of the coolant.
This could result in damage to cooling system components.
If Caterpillar products are not available and commercial
products must be used, make sure they have passed the
Caterpillar EC-1 specification for pre-mixed or concentrate
coolants and Caterpillar Extender.
Note: The machine was shipped from the factory with Extended Life Coolant (ELC) in the cooling system.
For information about the addition of Extender to your cooling system, see the Operation and Maintenance
Manual, "Cooling System Coolant (ELC) Extender - Add" or consult your Caterpillar dealer.
Drain the coolant whenever the coolant is dirty or whenever the coolant is foaming.
The radiator cap is located under the radiator guard on the top of the engine compartment.
Allow the machine to cool before you change the coolant.
1. Open the engine access door. Refer to Operation and Maintenance Manual, "Access Doors and
Covers".
2. Raise the radiator guard. Refer to Operation and Maintenance Manual, "Radiator Tilting".