
Illustration 4 g01030411
3. Remove the plug from the end of the drain hose. Pull the drain hose through the access panel in the
belly guard. Open the drain valve and drain the oil into a suitable container.
4. Close the drain valve and pull the drain hose back into the machine. Install the drain plug into the
drain hose.
5. Change the hydraulic system filter. Refer to Operation and Maintenance Manual, "Hydraulic System Oil
Filter - Change".
6. Fill the hydraulic system oil tank. Refer to Operation and Maintenance Manual, "Lubricant Viscosities"
and Operation and Maintenance Manual, "Capacities (Refill)".
7. Maintain the hydraulic oil level approximately in the middle of the sight gauge.
Check the oil level with the loader arms in the fully lowered position.
Note: The oil must be free of bubbles. If bubbles are present in the oil, air is entering the hydraulic
system. Inspect the suction hoses and hose clamps.
8. Install the hydraulic tank filler cap.
Copyright 1993 - 2012 Caterpillar Inc.
All Rights Reserved.
Private Network For SIS Licensees.
Sat Jan 28 2012 04:28:00 GMT-0800 ( ( ))