
Illustration 5 g00554036
9. Tighten the bolts for the axle housing in the order that is shown above to 160 ± 15 N·m (118 ± 11 lb
ft). Turn the nuts an additional 60 ±5° in the same order.
10. Remove the chain tension adjuster.
11. Install the bolts and the cover for the drive chain case.
Note: Use 8T-9022 Silicone Gasket in order to seal the cover to the machine.
12. Use an appropriate nylon lifting strap and a hoist in order to position the tire and rim to the axle. The
weight of the tire and rim is 51 kg (113 lb). Refer to Operation and Maintenance Manual, "Wheel Nuts
- Tighten" for the procedure to tighten the wheel nuts.
13. Lower the front of the machine to the ground. Repeat the procedure on the opposite side of the
machine if it is necessary.
14. Repeat the adjustment procedure on the rear drive chains if it is necessary.
Copyright 1993 - 2012 Caterpillar Inc.
All Rights Reserved.
Private Network For SIS Licensees.
Sat Jan 28 2012 04:24:38 GMT-0800 ( ( ))