
90 RENR9716-02
Disassembly and Assembly Section
i02296800
Cranksh aft - Install
SMCS Code: 1202
-012
Installation P
rocedure
Table 69
Required Tools
Tool
Part
Number Part Description Qty
A
138-7574
Link Bracket 2
D
8T-5096
Dial Indicator 1
E
8T-3052
Degree Wheel 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01150312
Illustratio
n 260
1. Install dowel (8) in the crankshaft.
Protrusion of dowel (8) from the crankshaft
face ........................................ 8.4 mm (0.33 inch)
2. Install dowel (9) in the crankshaft.
Protrusion o
f dowel (9) from the crankshaft
............................ 4.1 ± 0.5 mm (0.16 ± 0.02 inch)
3. Install cra
nkshaft gear (7) on the crankshaft with
the keyway in alignment with dowel (9). Timing
Mark “V” of the gear should face away from
crankshaft
(6).
Note: Install the main bearings dry when clearance
checks are p
erformed. Refer to Disassembly and
Assembly, “Bearing Clearance - Check”. Apply clean
engine oil on the main bearings for final assembly.
4. Install the upper halves of the main bearings in
the cylinder block.
Note: Ensure that the main bearings are installed so
that the bearin
gtabsfit into the notch in the cylinder
block. The upper halves of the main bearings have
the oil groove and the oil hole.
g01150344
Illustration 261
5. Install Tooling (A) and a suitable lifting device
on each end of crankshaft (6). The weight of
crankshaft (6) is approximately 188 kg (415 lb).
6. Install crankshaft (6) with Timing Mark “V” on the
crankshaft gear in alignment with Timing Mark “V”
on the cluster gear.
7. Install the thrust plates on each side of the No. 4
main bearing.
Note: Install the thrust plates with the words “Block
Side” toward the cylinder block.
8. Install the lower halves o f the crankshaft main
bearings in the main bearing caps.
Note: Ensure that the main bearings are installed
so that the bearing tabs fit into the notch in the main
bearing cap.
9. Position main bearing caps (4) on the crankshaft.
Note: Ensure that the numbers on the m ain bearing
caps match the numbers on the cylinder block. Also
ensure that the “FRONT” on the main bearing cap is
installed toward the front of the cylinder block.
10. Lubricate the threads of bolts (3) and bolts (5)
with clean engine oil. Install the bolts.
11. Tighten bolts (3) and bolts (5) for the main bearing
caps, as follows:
a. Tighten Bolt (A) to a torque of 258 ± 14 N·m
(190±10lbft).
Note: Bolt (A) is on the bearing tab side of the main
bearing cap.
b. Tighten Bolt (B) to a torque of 258 ± 14 N·m
(190±10lbft).