
RENR9716-02 63
Disassembly and Assembly Section
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01147965
Illustration 185
1. Remove tube assemblies (1).
2. Disconnect harness assemblies (5) and harness
assembly (2).
3. Remove bolts (4).
4. Remove valve mechanism cover base (3) and the
seal from the cylinder head.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01147965
Illustration 186
1. Install the seal on valve mechanism cover base
(3).
2. Position valve mechanism cover base (3) on the
cylinder head and install bolts (4).
3. Position harness assemblies (5) on the electronic
unit injectors. Tighten the cap nuts to a torque of
1.70±0.25N·m(15±2lbin).
4. Connect harness assembly (2).
5. Install tube assemblies (1).
End By:
a. Install the valve mechanism cover. Refer to
Disassembly and Assembly, “Valve Mechanism
Cover - Remove and Install”.
i02293245
Rocker Arm and Shaft -
Remove
SMCS Code: 1102-011
Removal Procedure
Table 46
Required Tools
Tool
Part
Number Part Description Qty
A
124-2946
Lifting Bracket 1