
132 RENR5622
Troubleshooting Section
Test Step 6. Check the Voltage to the Coil
of the Prelube Switch
A. Disconnect wire 337-WH from the coil of the
prelube switch.
B. Connect a voltmeter between wire 337-WH and
engine ground.
C. Turn the k eyswitch to the ON position.
D. Proceed to th
e “Diagnostic Overrides” screen on
Cat ET.
E. Activate the
prelube system.
F. Measure the voltage between wire 337-WH and
engine groun
d.
G. Turn the keyswitch to the OFF position.
H. Replace all wires to the original configuration.
Expected Res
ult:
The voltage measures 24 ± 3 VDC.
Results:
•
OK – The volta
ge is 24 ± 3 VDC. Proceed to Test
Step 7.
•
Not OK – The vo
ltage is not 24 ± 3 VDC.
Repair: Perform the following steps.
1. Remove wire 337-WH from terminal 85 on the
prelube relay. Activate the prelube override and
measure the
voltage between terminal 85 on
the prelube relay and engine ground. If voltage
is present on terminal 85 on the prelube relay,
repair the
wire 337-WH.
If 24 ± 3 VDC is not present on terminal 85
on the prel
ube relay, measure the voltage to
terminal 30 on the prelube relay. If 24 ± 3 VDC
is not present on terminal 30 of the prelube
relay, ver
ify that the 20A start aid breaker is
not tripped. Verify that the wiring between the
battery and the prelube relay is OK.
2. If 24 ± 3 VDC is present on terminal 30 on the
prelube relay, replace the prelube relay and
retest th
e prelube system.
STOP.
Test Step 7. C heck the Voltage at the
Prelube Motor
A. Disconnect the wire to the prelube motor from the
prelube switch at the prelube motor.
B. Connect a voltmeter between the wire and engine
ground.
C. Turn the keyswitch to the ON position.
D. Proceed to th
e “Diagnostic Overrides” screen on
Cat ET.
E. Activate the
prelube system.
F. Measure the voltage between the wire and engine
ground.
G. Turn the keyswitch to the OFF position.
H. Replace all wires to the original configuration.
Expected Res
ult:
The voltage is 24 ± 3 VDC.
Results:
•
OK – The volta
ge is 24 ± 3 VDC. Proceed to Test
Step 8.
•
Not OK – The vo
ltage is not 24 ± 3 VDC.
Repair: Perform the following steps.
1. Remove the wire to the prelube motor from the
prelube switch at the prelube switch. Activate
the prelube
override and measure the voltage
between the terminal on the prelube switch
and engine ground. If voltage is present on the
terminal, r
epair the wire to the prelube motor.
2. If voltage is not present on the terminal, verify
that the wi
re 200-BK has continuity to engine
ground. If wire 200-BK has continuity to engine
ground, measure the voltage to the other side of
the contac
ts of the prelube switch. If 24 ± 3 VDC
is present on the contacts of the prelube switch
and the wire 200-BK is not open, replace the
prelube s
witch and retest the prelube system.
3. If 24 ± 3 VDC is not present on the other side
of the con
tacts of the prelube switch, repair
the wiring between the battery and the prelube
switch.
STOP.