
108 RENR5622
Troubleshooting Section
•
Not OK – There is a problem in the connectors
and/or wiring.
Repair: Repair the connectors or wiring and/or
replace the co
nnectors or wiring. Ensure that all of
the seals are properly in place and ensure that the
connectors are completely coupled.
Verify that the repair eliminates the problem.
STOP.
Test Step 3. Check the Switch Circuit
A. Turn the keyswitch to the OFF position.
B. Disconnect th
e connector for the fuel filter
differential pressure switch.
C. Install a wire
jumper between the terminals of the
connector for the fuel filter differential pressure
switch. Install the wire jumper on the harness side
of the connec
tor.
D. Start the engine. Increase the engine speed to
high idle.
E. Monitor the active diagnostic code screen on Cat
ET. Check an
d record any active diagnostic codes.
Note: Wait at least 30 seconds in order for the
diagnostic
codes to become active.
F. Check for an event code for the engine fuel filter
restrictio
n.
Expected Result:
The event code is not active.
Results:
•
OK – The event code is not active. The wiring
between the
connector and the ECM is OK.
Repair: Check for a plugged fuel filter. If the
fuel filte
r is OK, temporarily replace the fuel filter
differential pressure switch. Verify that the problem
is resolved before permanently replacing the fuel
filter dif
ferential pressure switch.
STOP.
•
Not OK – The event code is still active. There
is an open circuit in the wiring for the fuel filter
differen
tial pressure switch between the connector
and the ECM. Proceed to Test Step 4.
Test Step
4. Ch eck the ECM
A. Turn the keyswitch to the OFF position.
B. Disconnect the J1/P1 ECM connector.
C. Install a jumper wire with Deutsch sockets on each
end into the socket for the signal wire of the fuel
filter differ
ential pressure switch.
D. Install a wire jumper between the wire jumper
in the socket f
or the return wire of the fuel filter
differential pressure switch.
E. Short the jump
er wires for the fuel filter differential
pressure switch together.
F. Reconnect th
e ECM connector.
G. Start the engine. Increase the engine speed to
high idle.
H. Monitor the active diagnostic code screen on Cat
ET. Check and
record any active diagnostic codes.
Note: Wait at least 30 seconds in order for the
diagnostic c
odes to become active.
I. Remove the short between the jumper wires for
the fuel fil
ter differential pressure switch.
J. Monitor the active diagnostic code screen on Cat
ET. Check an
d record any active diagnostic codes.
Note: Wait at least 30 seconds in order for the
diagnostic
codes to become active.
Expected Result:
The event code is not active when the jumper wires
are shorted together. The event code is active when
the jumper
wires are not shorted together.
Results:
•
OK – The ECM detects the open and the short.
Repair: The
re is an open or a short in the wiring
between the connector for the fuel filter differential
pressure switch and the ECM. Repair the
connector
s or wiring and/or replace the connectors
or wiring. Check the harness connector to the
fuel filter differential pressure switch for a good
connectio
n.
Verify that the repair eliminates the problem.
STOP.
•
Not OK – Th
e ECM does not detect the open or
the short.