
98 SEBU8088-06
Maintenance Section
Engine Protective Devices - Check
NOTICE
Do not fill the oi
l filters with oil before installing them.
This oil would not be filtered and could be contaminat-
ed. Contaminated oil can cause accelerated wear to
engine compon
ents.
5. Install the oil filter. Tighten the oil filter until the
oil filter gask
et contacts the base. Tighten the oil
filter by hand according to the instructions that are
shownontheoilfilter. Do not overtighten the oil
filter.
Fill the Engi
ne Crankcase
1. Remove the oil filler cap. Refer to the Operation
and Maintena
nce Manual, “Refill Capacities and
Recommendations” for more information.
NOTICE
If equipped with an auxiliary oil filter system or a re-
mote oil fi lte
r system, follow the OEM or filter manu-
facturer’s recommendations. Under filling or overfilling
the crankcase with oil can cause engine damage.
NOTICE
To prevent crankshaft bearing damage, crank the en-
gine with the fuel OFF. This will fill the oil filters before
starting the engine. Do not crank the engine for more
than 30 seconds.
2. Start the engine and run the engine at “LOW
IDLE” for two minutes. Perform this procedure in
order to ensure that the lubrication system has
oil and that the oil filters are filled. Inspect the oil
filter for oil leaks.
3. Stop the engine and allow the oil to drain back to
thesumpforaminimumoftenminutes.
4. Remove the oil level gauge in order to check the
oil level. Maintain the oil level between the “ADD”
and “FULL” marks on the oil level gauge.
i00626013
Engine Protective Devices -
Check
SMCS Code: 7400-535
Alarms and shutoffs must function properly. Alarms
provide timely warning to the operator. Shutoffs help
to preven
t damage to the engine. It is impossible
to determine if the engine protective devices are
in good working order during normal operation.
Malfunc
tions must be simulated in order to test the
engine protective devices.
A calibration c
heck of the engine protective devices
will ensure that the alarms and shutoffs activate
at the setpoints. Ensure that the engine protective
devices are fu
nctioning properly.
NOTICE
During testing, abnormal operating conditions must be
simulated.
The tests must be performed correctly in order to pre-
vent possible
damage to the engine.
To prevent damage to the engine, only authorized
service pers
onnel or your Caterpillar dealer should
perform the tests.
Visual Inspection
Visually che
ck the condition of all gauges, sensors
and wiring. Look for wiring and components that
are loose, broken, or damaged. Damaged wiring
or componen
ts should be repaired or replaced
immediately.
i02562758
Engine Valve Lash -
Inspect/Adjust
SMCS Code: 1102-025
NOTICE
Only qualified service personnel should perform this
maintenance. Refer to the Service Manual or your
Caterpillar dealer for the complete valve lash adjust-
ment procedure.
Operation of Caterpillar engines with improper valve
adjustments can reduce engine efficiency. This re-
duced efficiency could result in excessive fuel usage
and/or shortened engine component life.
The initial valve lash adjustment on new engines,
rebuilt engines, or remanufactured engines should
be performed at the first oil change. The initial valve
lash adjustment on new engines, rebuilt engines, or
remanufactured engines must be performed before
the fourth oil change, or at the fourth oil change. The
adjustment is necessary due to the initial wear of
the valve train components and to the seating of the
valve train components.
This maintenance is part of a lubrication and
preventive maintenance schedule in order to help
provide maximum engine life.