
16 SEBU8088-06
Safety Section
Fire Prevention and Explosion Prevention
Use caution whe
n you are refueling an engine. Do
not smoke while you are refueling an engine. Do not
refuel an engine near open flames or sparks. Always
stop the engin
e before refueling.
g00704135
Illustration 12
Gases from a battery can explode. Keep any open
flames or sparks away from the top of a battery. Do
not smoke in battery charging areas.
Never check the battery charge by placing a metal
object across the terminal posts. Use a voltmeter or
ahydrometer.
Improper jumper cable connections can cause
an explosion that can result in injury. Refer to
the Operation Section of this manual for specific
instructions.
Do not charge a frozen battery. This may cause an
explosion.
The batteries must be kept clean. The covers
(if equipped) must be kept on the cells. Use the
recommended cables, connections, and battery box
covers when the engine is operated.
Fire Extinguisher
Make sure that a fire extinguisher is available. Be
familiar with the operation of the fire extinguisher.
Inspect the fire extinguisher and service the fire
extinguisher regularly. Obey the recommendations
on the instruction plate.
Ether
Ether is flammable and poisonous.
Use ether in wel
l ventilated areas. Do not smoke
while you are replacing an ether cylinder or while you
are using an ether spray.
Do not store ether cylinders in living areas or in the
engine compartment. Do not store ether cylinders
in direct sun
light or in temperatures above 49 °C
(120 °F). Keep ether cylinders away from open
flames or sparks.
Dispose of used ether cylinders properly. Do not
puncture an ether cylinder. Keep ether cylinders
away from una
uthorized personnel.
Do not spray ether into an engine if the engine is
equipped wit
h a thermal starting aid for cold weather
starting.
Lines, Tu bes and Hoses
Do not bend h
igh pressure lines. Do not strike high
pressure lines. Do not install any lines that are bent
or damaged.
Repair any lines that are loose or damaged. Leaks
can cause fires. Consult your Caterpillar dealer for
repair or f
or replacement parts.
Check lines, tubes and hoses carefully. Do not use
your bare h
andtocheckforleaks.Useaboardor
cardboard to check for leaks. Tighten all connections
to the recommended torque.
Replace the parts if any of the following conditions
are present:
•
End fittings are damaged or leaking.
•
Outer cov
erings are chafed or cut.
•
Wires are exposed.
•
Outer coverings are ballooning.
•
Flexible
part of the hoses are kinked.
•
Outer covers have embedded armoring.
•
End fittings are displaced.
Make sure
that all clamps, guards, and heat shields
are installed correctly. During engine operation, this
will help to prevent vibration, rubbing against other
parts, an
d excessive heat.