
202
Operation Section (Pipelayer Attachment Kit) WEBM1000
Before Operation
Accumulator - Relieving Charge
To relieve the accumulator charge, with no load on
the hook and the engine stopped, move the hook
control lever from "HOLD" to "RAISE" 10 times.
Boom Control (4)
HOLD – The lever self centres to this position
whenever it is released. In this position
, the boom
winch brake will set, and the boom will stop and
remain at the position it is in.
LOWER – Move the lever to this position to
lower the boom. The further the lever is pushed
away from H
OLD, the faster the boom will lower. The
closer the lever is toward HOLD, the slower the
boom will lower. When the lever is released, it will
return to the HOLD position, and the boom will stop
and remain at the position it is in. Boom winch line
speed varies with engine throttle setting. Boom
control is smoothest at engine speeds faster than
idle.
RAISE – Move the lever to this position to
raise the boom. The further the lever is pulled away
from HOLD, the faster the boom will raise.
The closer
the lever is toward HOLD, the slower the boom will
raise. When the lever is released, it will return to the
HOLD position, and the boom will stop and remain at
the position it is in. Boom winch line speed varies
with engine throttle setting. Boom control is
smoothest at engine speeds faster than idle.
Boom Stop Valve
The Boom Stop valve is a safety device that is
intended to automatically stop the boom winch from
hauling-in when the boom is vertical, preventing
overloading of key machine components. Refer to
the Operation and Maintenance manual, Boom Stop
Valve Adjustment, for correct operation and
adjustment. Check its function daily.
Counterweight Control (5)
NOTICE
In order to prevent machine damage, check to make
sure the coun
terweight lock lever is not locked in the
extended position before you operate this control
lever. Refer to Operation and Maintenance manual,
"Safety Section".
Hold - When the operator releases the counterweight
control from any position, the control will return to the
HOLD and the counterweight will remain in position.
Out - Move the counterweight control to this position
in
order to
move the counterweight outward. When
the counterweight control is released, the returns to
the HOLD position and the counterweight will remain
in position.
Refer to the Operation and Maintenance Manual,
"
Coun
terweight Lock Lever" for the procedure to
mechanically lock the counterweight in the fully
extended position when you service the machine.
In - Move the counterweight control lever to this
po
sition
in order to move the counterweight inward.
When you release the counterweight control lever
the lever returns to the HOLD position and the
counterweight will remain in position.
Counterweight Control-Lockout
Lever (6)
Use the counterweight control-lockout lever (6) to
lock the counterweight control (5) in the HOLD
position in order to avoid accidental actuation of the
counterweight. Move the counterweight control (5) to
the HOLD position. Flip the counterweight control-
lockout lever (6) forward in order to lock the
counterweight control (5) in the HOLD position.
Flip the lock lever (6) to the rear position in order to
allo
w ac
tuation of the counterweight control.