
162
Maintenance Section (D6T LGP (OEM)) WEBM1000
Pivot Shaft Oil Level - Check
Nonferrous metals can indicate wear on the
aluminum parts of the engine such as main
bearings, rod bearings, or turbocharger bearings.
Small amounts of debris may
be foun
d in the filter
element. This could be caused by friction and by
normal wear. Consult your Caterpillar dealer in order
to arrange for further analysis if an excessive
amount of debris is found.
Using an oil filter element that is not recommended
by
Caterpillar can res
ult in severe engine damage to
engine bearings, to the crankshaft, and to other
parts. This can result in larger particles in unfiltered
oil. The particles could enter the lubricating system
and the particles could cause damage.
Pivot Shaft Oil Level - Check
Hot oil and components can cause personal
injury.
Do not allow hot oil or components to contact
skin.
223
Illustration 223
The oil plugs are located on both sides of the
machine on top of the track roller frame.
1. Remove the oil plugs on one side of the machine.
Check the oil level. The oil level s
hould be at the
bottom of the threaded hole.
2. If
necessary, add oil in order to bring the oil level
up to th
e bottom of the threaded hole.
Reference: Se
e Oper
ation and Maintenance
Manual, “Lubricant Viscosities” in this manual for the
correct viscosity grade.
3. Install
the oil plugs.
4. Repeat Steps 1 thro
ugh 3 on the other side of the
machine.
Radiator Core - Clean
224
Illustration 224
You can use compressed air, high-pressure water, or
steam to remove dust and other debris from the
radiator core and the aftercooler core. However, the
use of compressed air is preferred.
See Special Publication, SEBD0518, “Know Your
Coo
ling System” fo
r the complete procedure for
cleaning the radiator core.
Radiator Pressure Cap - Clean/
Replace
At operating temperature, the engine coolant is
hot and under pressure.
Steam can cause personal injury.
Check the coolant level only after the engine has
been stopped an
d the fill cap is cool enough to
touch with your bare hand.
Remove the fill cap slowly to relieve pressure.
Cooling system conditioner contains alkali.
A
void con
tact with the skin and eyes to prevent
personal injury.