
142
Maintenance Section (D6T LGP (OEM)) WEBM1000
Engine Valve Lash - Check/Adjust
15. Check the oil level. If necessary, add oil. To
ensure that the correct amount of oil was added,
always measure the oil level with the engine oil
dipstick (5). Refer to Operation and Maintenance
Manual, “Engine Oil Level - Check” for more
information.
16. St
op the engine. Close the engine access doors.
Engine Valve Lash - Check/
Adjust
To prevent possible injury, do not use the starter
motor to turn the flywheel.
Hot engine components can cause burns. Allow
additional time for the engine to cool before
measuring valve clearance.
Electrical shock hazard. The electronic unit
injector system uses 90-120 volts.
NOTICE
Operation of Caterpillar engines with improper valve
adjustments will reduce engine efficiency
. This
reduced efficiency could result in excessive fuel
usage and/or shortened engine component life.
NOTICE
Measure the valve clearance with the engine
stopped. T
o obtain an accurate measurement, allow
at least 20 minutes for the valves to cool to engine
cylinder head and engine block temperature.
Check the valve bridge before setting the valve lash.
Ensure that the valve bridge is seated equally on
both valve stems.
NOTICE
Only qualified service personnel should perform this
mainten
ance. Refer to the Systems Operation/
Testing and Adjusting Manual, “Valve Lash and Valve
Bridge Adjustment” article or consult your Caterpillar
dealer for the complete valve lash adjustment
procedure.
Equalizer Bar Center Pin -
Lubricate
NOTICE
Apply lubricant to the fittings with a hand operated
grease gun on
ly. Use of pressure operated
lubricating equipment damages the seals.
180
Illustration 180
8F-9866 Grease Gun
181
Illustration 181
Remote Fitting
Lubricate the equalizer bar center pin through the
remote fitting. The remote fitting is located on the
frame on the left side of the machine. The fitting is
located below the dipstick.
The proper lubricant for the center pin is the “Desert
Gold”.
NLGI 2 grease
Ref
er to Operation and Maintenance Manual,
SEBU6250
“Lubricating Greases” for more
information.