
58 31200243
Operation Section
Quick Coupler (Tilt Forward) - Push the
joystick control to the right in order to tilt the
quick coupler forward. When the joystick
control is released the joystick control will return to the
HOLD position.
Quick Coupler (Tilt Backward) - Push the
joystick control to the left in order to tilt the
quick coupler backward. When the joystick
control is released the joystick control will return to the
HOLD position.
Boom Extend - Move thumb wheel (13B)
forward in order to extend the boom. When the
thumb wheel is released the thumb wheel will
return to the HOLD position.
Note: The boom will not extend when the
transmission control is in the REVERSE position. The
function for extending the boom will resume if the
transmission is neutralized by the service brake, the
parking brake, or the transmission neutralizer button.
Boom Retract - Move thumb wheel (13B)
backward in order to retract the boom. When
the thumb wheel is released the thumb wheel
will return to the HOLD position.
Auxiliary Controls - If equipped, press
switch (13E) in order to toggle between the
hydraulic circuits for the auxiliary 1 and
auxiliary 2. Move thumb wheel (13C) forward in order to
operate an actuator for a work tool in the positive
direction. Move thumb wheel (13C) backward in order to
operate an actuator for a work tool in the negative
direction. Switch (13E) is not operated proportionally.
Illustration 75 g01017263
When auxiliary 2 is selected, indicator light (13G) will be
illuminated.
The speed of the following functions is governed by the
amount of movement of the joystick control and engine
speed:
•Boom raise
• Boom lower
• Quick coupler (tilt forward)
• Quick coupler (tilt backward)
For smooth operation, first increase the engine speed
from low idle. Then move joystick control (13) slowly
until the attachment is moving at the required speed.
The speed of the boom extend and boom retract is
governed by the amount of movement of thumb wheel
(13B).
Move joystick control (13) diagonally in order to
simultaneously tilt the quick coupler forward or
backward while the boom is being raised or lowered.
Move joystick control (13) diagonally. At the same time
operate thumb wheel (13B) in order to simultaneously
tilt the quick coupler while the boom is being operated
in two directions.
Type B Control Arrangement (Single Thumb
Wheel)
Illustration 76 g00978869
Machines that have the Type B control arrangement are
equipped with decal (13F) that is shown above. Joystick
control (13) operates in the following way:
Illustration 77 g01213463
Boom Raise - Pull joystick control (13)
backward in order to raise the boom. When