
134 31200243
Maintenance Section
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component
containing fluids.
Refer to Special Publication, NENG2500, "Caterpillar
Dealer Service Tool Catalog" for tools and supplies
suitable to collect and contain fluids on Caterpillar
products.
Dispose of all fluids according to local regulations and
mandates.
1. Park the machine on level ground. Fully retract
and fully lower the boom. Move the transmission
control to the NEUTRAL position and ensure that
the parking brake is engaged. Shut off the engine.
2.
Open the engine enclosure.
Illustration 260 g00976267
3. Loosen the valve and drain the water and
sediment into a suitable container.
4. Tighten the valve.
Fuel System Water Separator
Element - Replace
Personal injury or death may result from failure to
adhere to the following procedures.
Fuel leaked or spilled onto hot surfaces or electrical
components can cause a fire.
Clean up all leaked or spilled fuel. Do not smoke while
working on the fuel system.
Turn the disconnect switch OFF or disconnect the
battery when changing fuel filters.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component
containing fluids.
Refer to Special Publication, NENG2500, "Caterpillar
Dealer Service Tool Catalog" for tools and supplies
suitable to collect and contain fluids on Caterpillar
products.
Dispose of all fluids according to local regulations and
mandates.
1. Park the machine on level ground. Fully retract
and fully lower the boom. Move the transmission
control to the NEUTRAL position and ensure that
the parking brake is engaged. Shut off the engine.
2. Open the engine enclosure.
Illustration 262 g00976197
3. Loosen valve (3) and drain the contents of housing
(2) into a suitable container. Tighten the valve.
4. Support housing (2) and rotate the housing.
Remove the housing.
5. Rotate the element for 90 degrees
counterclockwise and lift the element out of
housing (2).
6. Clean the gasket sealing surface on mounting
base (1). Replace the O-ring seal that is located on
housing (2). Insert a new filter element into the
housing and rotate the element for 90 degrees
clockwise in order to lock the element into position.
7. Lubricate the O-ring seal on the new element with
clean diesel fuel.
8. Install the housing onto the mounting base.
Tighten the housing by hand. Do not overtighten the
housing.
Note: Ensure that the O-ring seal is not damaged
during the installation of the housing. Replace the O-
ring if the O-ring is damaged.