
31200243 129
Maintenance Section
Illustration 246 g00975860
3. Position the end of hose (3) into a suitable
container. Turn shutoff valve (2) counterclockwise in
order to drain the engine oil from the crankcase.
Turn the shutoff valve clockwise in order to close
the shutoff valve. Allow the oil to drain from the
hose.
4. Remove old engine oil filter (1) with a filterwrench.
5. Clean the filter housing base. Ensure that all of the
old seal is removed.
6. Apply a thin film of clean engine oil to the seal of
the new engine oil filter.
7. Install new engine oil filter (1) hand tight until the
seal of engine oil filter (1) contacts the base. Note
the position of the index marks on the filter in
relation to a fixed point on the filter base.
Note: There are rotation index marks on engine oil filter
(1) that are spaced 90 degrees or 1/4 of a turn away
from each other. When you tighten engine oil filter (1),
use the rotation index marks as a guide.
8. Tighten the filter according to the instructions that
are printed on the filter. Use the index marks as a
guide. For non-Caterpillar filters, refer to the
installation instructions that are provided by the
supplier of the filter.
Note: You may need to use a Caterpillar strap wrench,
or another suitable tool, in order to turn the filter to the
amount that is required for final installation. Make sure
that the installation tool does not damage the filter.
Illustration 249 g01081070
9. Remove filler cap (4) and fill the crankcase with new
oil.
10. Refer to Operation and Maintenance Manual,
"Lubricant Viscosities" for more information on the
type of oil that is required. Refer to Operation and
Maintenance Manual, "Capacities (Refill)" for more
information on the quantity of oil that is required.
11. Check that the parking brake is engaged and that
the transmission is in NEUTRAL and then start the
engine. Operate the engine for five minutes at low
idle. Inspect the engine for leaks and make any
repairs that are necessary.
12. Stop the engine. Wait for two minutes after you
stop the engine. Stopping the engine allows oil to
drain back to the crankcase. Check the oil level. If
necessary, add oil. Maintain the oil level between
the "ADD" mark and the "FULL" mark on the
dipstick. Install the filler cap.
13. Close the engine access door.
Engine Valve Lash - Check
Maintenance is recommended by Caterpillar for engine
valve lash adjustments. The maintenance for the
engine valve lash is part of the lubrication and
preventive maintenance schedule in order to provide
maximum engine life.
Note: The engine valve lash should be checked at
every 2000 hours or 2 years.
NOTICE
Only qualified service personnel should perform this
maintenance. Refer to the Service Manual or your
Caterpillar Dealer for the complete engine valve lash
adjustment procedure.