
118
Maintenance Section
Fuel System Primary Filter - Clean/Replace
11. Prime the fuel system in order to fill the water
separator element with fuel.
Reference: Refer to Operation and Maintenance
Manual, “Fuel System - Prime” for the correct
procedure.
12. Close the engine access door.
i01380766
Fuel System Primary Filter -
Clean/Replace
SMCS Code: 1260-070; 1260-510
g00729143
Illustration 191
1. Open the engine access door on the right side
of the machine.
g00729161
Illustration 192
g00283342
Illustration 193
2. Loosen retaining bolt (1).
3. Remove filter housing (3) and filter element (4).
4. Wash the filter element and the filter housing in
a clean, nonflammable solvent.
5. Dry the filter element with pressure air.
6. Clean the filter housing base.
7. Inspect seal (2). Replace the seal if the seal is
damaged.
8. Insert the clean filter element into the filter
housing.
NOTICE
Do not fill fuel filters with fuel before installing them.
Contaminated fuel will cause accelerated wear to fuel
system parts.
9. Install the filter housing onto the filter housing
base.
10. Tighten retaining bolt (1) to a torque of
24 ± 4 N·m (18 ± 3 lb ft).