
106
Maintenance Section
Drive Shaft Spline (Center) - Lubricate
2. Remove dipstick/fill plug (1) on the left side of
the axle. Wipe off the level gauge with a clean
cloth and reinsert the plug. This will ensure a
more accurate measurement of the oil level.
Note: Make sure that the plug is installed completely
before you check the oil level. If the plug is not
installed completely, an incorrect oil level reading
can occur.
3. Remove dipstick/fill plug (1) again and check the
oil level. Maintain the oil level between the ADD
mark and the FULL mark. Add oil, if necessary.
Reference: Refer to Operation and Maintenance
Manual, “Lubricant Viscosities and Refill
Capacities” for the type of lubricant and for the
refill capacity.
4. Clean the plug and install the plug.
i01562087
Drive Shaft Spline (Center) -
Lubricate
SMCS Code: 3253-086-SN
Note: For better access to the fitting, articulate
the machine to the right or to the left. Since the
steering frame lock cannot be connected in this
case, remove the engine start switch key and turn
the battery disconnect switch to the OFF position.
Wipe off the fitting before you apply any lubricant.
g00811338
Illustration 158
Apply lubricant through the fitting for the center
drive shaft spline.
i01562133
Drive Shaft Support Bearing -
Lubricate
SMCS Code: 3267-086-BD
Wipe off the fitting before any lubricant is applied.
g00811351
Illustration 159
Apply lubricant through the remote fitting on the
right side of the machine. Use the fitting that is
toward the rear of the machine.
i01119388
Drive Shaft Universal Joints -
Lubricate
SMCS Code: 3251-086
Wipe off all fittings before any lubricant is applied.
g00291135
Illustration 160
Apply lubricant through one fitting on each universal
joint. There is a total of five fittings.