
105
Maintenance Section
Differential and Final Drive Oil Level - Check
g00287531
Illustration 155
Typical Example
Rear Axle
Note: The axle housings are equipped with
magnetic drain plugs.
1. Remove drain plugs (2). Allow the oil to drain
into a suitable container.
2. Clean the drain plugs and install the drain plugs.
3. Wipe off dipstick/fill plugs (1) and the surfaces
around dipstick/fill plugs (1).
4. Remove the dipstick/fill plugs. Fill the axles with
oil.
Reference: Refer to Operation and Maintenance
Manual, “Capacities (Refill)” for the type of
lubricant and for the refill capacity.
5. Clean the dipstick/fill plugs and install the
dipstick/fill plugs.
6. Run the machine on level ground for a few
minutes in order to equalize the oil level in the
axle. Check the oil level in the axle.
Reference: Refer to Operation and Maintenance
Manual, “Differential and Final Drive Oil Level -
Check” for the correct procedure.
i01102280
Differential and Final Drive Oil
Level - Check
SMCS Code: 3278-535-FLV; 4011-535-FLV
Note: Before you measure the oil level, operate the
machine for a few minutes in order to equalize the
oil level.
1. Park the machine on level ground. Lower the
bucket and apply slight downward pressure.
Engage the parking brake. Stop the engine.
g00285312
Illustration 156
Front Axle
g00287527
Illustration 157
Rear Axle