
70
Excavator Supplement for 3066 Engine
Disassembly and Assembly Section
Fan - Remove and Install
SMCSCode: 1356-011; 1356-012
Removal Procedure
Illustration 283
The radiator is removed for photographic purposes.
2. Install alternator V-belts (7).
3. Use tension adjusting bolt (6) to adjust the
tension of the alternator V-belts. Refer to the
Operation and Maintenance Manual for the
correct procedure for adjusting the tension of
the V-belts.
4. Tighten bolts (5) and (8).
Illustration 284 9
00709780
The radiator is removed for photographic purposes.
5. Install air conditioner V-belt (4).
6. Partially tighten the mounting bolt (2).
7. Use tension adjusting bolt (3) to adjust belt
tensioner (1). Refer to the Operation and
Maintenance Manual for the correct procedure
for adjusting the tension of the V-belts.
8. Fully tighten the mounting bolt (2).
End By:
a. Install the fan. Refer to Disassembly and
Assembly, "Fan - Remove and Install" in this
manual.
WARNING
At operating temperature, the engine coolant is
hot and under pressure.
Steam can cause personal injury.
Check the coolant level only after the engine has
been stopped and the filler cap is cool enough to
touch with the bare hand.
Remove the filler cap slowly to relieve pressure.
Cooling system conditioner contains alkali. Avoid
contact with skin and eyes to prevent personal in-
jury.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Refer to Special Publication, NENG2500, "Caterpillar
Tools and Shop Products Guide" for tools and supplies
suitable to collect and contain fluids on Caterpillar
products.
Dispose of all fluids according to local regulations and
mandates.
Illustration 285
1. Open hood (1).