
106
Excavator Supplement for 3066 Engine
Disassembly and Assembly Section
54. Remove bolt (48), the washer, and the harness
clip.
Illustration 412
50. Disconnect electrical connection (43) from the
refrigerant compressor.
Illustration 415
55. Remove the bolts and the washers that fasten
the harness clips (49) to the engine.
Note: Put identification marks on all wires prior to
the removal of the electric starting motor.
Illustration 413
51. Remove
two bolts (45) and the washers.
52. Disconnect two tube assemblies (44). Put tape
over the ends of the tube assemblies. Put tape
over the holes in the refrigerant compressor.
Tape will help to prevent contaminating the
refrigerant system.
Illustration 414 g00722093
53. Disconnect electrical connections (46) and (47).
Illustration 416
56. Remove bolt (50) and the washer in order to
remove the wiring clip.
57. Remove rubber boot (51). Slide the rubber boot
down the battery cable in order to access the
nut under the rubber boot.